← Back to Blog

Radon Mitigation in New Construction: Build It In, Don't Retrofit

Radon is the second leading cause of lung cancer after smoking. It's a radioactive gas that seeps from soil through foundation cracks and gaps. Installing a radon mitigation system during new construction costs a fraction of a retrofit — and it's increasingly required by code.

What Is Radon?

Radon is a naturally occurring radioactive gas produced by the decay of uranium in soil and rock. It's colorless, odorless, and present everywhere in varying concentrations. The EPA action level is 4.0 picocuries per liter (pCi/L). About 1 in 15 homes in the US has elevated radon. You can't predict it by geology alone — neighboring houses can have very different levels.

Passive Radon System Design

A passive radon system installed during construction includes: a gas-permeable layer under the slab (4" of clean gravel), a 3" or 4" PVC pipe extending from below the slab through the roof, a sealed slab (poly vapor barrier under slab, sealed penetrations and cracks), and a labeled electrical junction box in the attic near the pipe for a future fan. Total material cost: under $200.

The Gravel Layer

The gravel layer beneath the slab is critical. It provides a continuous air space where radon can collect and be drawn toward the PVC suction point. Use clean, washed gravel — not crusher run with fines that pack tight and restrict air movement. Extend it under the entire slab area. This also functions as a capillary break for soil moisture.

Build Your Own House? 42-page guide • 27 construction steps • 40+ years of field-tested knowledge
Get the Guide — $29

Pipe Routing

Route the PVC pipe from the sub-slab gravel vertically through an interior wall, through the attic, and out the roof. Interior routing ensures the pipe stays warm (warm air rises, aiding passive stack effect). Don't run it through an exterior wall where it can freeze. Label the pipe "RADON" at every visible point. Extend it at least 12" above the roof penetration.

Passive vs. Active

A passive system relies on the stack effect to draw radon up and out. It works in many cases but not all. If post-construction testing shows radon above 4.0 pCi/L, adding a fan to the pipe converts it to an active system — and that's where the electrical junction box you installed pays off. Activating a passive system costs $200-300 (fan installation). Retrofitting an entire system into an existing home costs $1,000-2,500.

Sealing the Slab

Seal every slab penetration: plumbing pipes, electrical conduits, sump lids, expansion joints, and any cracks that develop. Use polyurethane caulk for small gaps and hydraulic cement for larger ones. The slab is the primary barrier — the mitigation pipe handles what gets through, but a tight slab reduces the load on the system.

Testing After Occupancy

Always test after the home is occupied and lived in for at least a month. Short-term test kits (48-96 hours) are available at hardware stores for $10-15. For definitive results, use a continuous radon monitor or long-term (90-day) test kit. Advise your clients to test — it's their health at stake, and the mitigation system you installed makes the fix simple if needed.

Ready to Build Smarter?

Get the complete 42-page owner-builder guide — 27 construction steps from a builder with 40+ years experience and 1,000+ homes.

Get the Guide — $29
★★★★★
"This guide saved me from making a $40,000 mistake on my foundation. Worth every penny of the $29."
— Marcus T., Bozeman, MT

Free Building Tips — Straight to Your Inbox

Get practical construction advice from a builder with 40+ years and 1,000+ homes. No spam, ever.