In a slab-on-grade home, the concrete slab extends from the heated interior directly to the exterior. That exposed edge is a massive thermal bridge — cold transfers through the concrete, making floors uncomfortable and wasting energy. Yet it's one of the most commonly skipped insulation details.
Why the Edge Matters
Concrete is a good thermal conductor. An uninsulated slab edge connects the warm floor surface directly to outdoor temperatures. In winter, heat flows from the slab through the edge to the cold exterior. The perimeter 3-4 feet of floor is noticeably colder than the center. This temperature difference drives heat loss and creates comfort complaints.
How Much Energy Is Lost
Slab edge heat loss is calculated per linear foot of exposed perimeter, not by area. In climate zone 5, an uninsulated slab edge loses roughly 8-10 BTU per hour per linear foot during design conditions. For a 40x50 ft house (180 linear feet), that's 1,800 BTU/hr — equivalent to leaving a window wide open. Over a heating season, it adds up to real money.
Exterior vs. Interior Insulation
Exterior slab edge insulation is preferred — it keeps the concrete warm and eliminates the thermal bridge at the foundation-to-slab joint. Rigid XPS or EPS foam, minimum R-10, extends from the top of the slab to at least 24" below grade (or to the footing in colder climates). It must be protected above grade with a durable coating or flashing because foam degrades in UV sunlight.
Interior Insulation Alternative
If exterior insulation isn't possible (retrofit, specific foundation details), interior perimeter insulation works too. Install rigid foam vertically against the interior face of the stem wall and horizontally under the slab for 2-4 feet from the edge. This doesn't completely eliminate the thermal bridge but significantly reduces perimeter heat loss.
Termite Considerations
In termite-prone regions, exterior foam against the foundation creates a hidden pathway for termites. Some jurisdictions prohibit it entirely. Solutions include: using borate-treated foam, leaving a visible inspection gap at the top of the foam, using stainless steel termite mesh between foam and foundation, or relying on interior insulation only. Check local codes and pest management recommendations.
Sub-Slab Insulation
Full sub-slab insulation (rigid foam under the entire slab) is required by energy code in climate zones 4 and above. Minimum R-10 is typical. This reduces heat loss through the slab to ground, improves floor comfort, and reduces condensation risk on the slab surface. Combined with edge insulation, the slab becomes a comfortable, energy-efficient floor system.
The Comfort Payoff
Homeowners in slab-on-grade homes consistently complain about cold floors. The fix is almost always inadequate or missing slab edge insulation. For new construction, the cost is trivial — a few hundred dollars in foam. For existing homes, it's more involved but the comfort improvement is dramatic. Warm feet make happy homeowners.