← Back to Blog

Skylight Installation and Flashing: Where Leaks Start

Skylights are one of the most leak-prone elements in residential construction. They're penetrations in the most water-exposed surface of the building, installed in a sloped application that concentrates water flow. Done right, they last decades without a problem. Done wrong, they leak on the first heavy rain and the calls start immediately.

Unit Selection Matters

Not all skylights are equal. Specify NFRC-rated units with minimum U-factor and solar heat gain appropriate to climate. For most climates, double-pane low-e glass with thermally broken frames is the baseline. Curb-mounted vs. deck-mounted units have different flashing requirements — know which you're installing before ordering. Velux, Fakro, and similar premium brands include integrated flashing kits engineered for their specific units. Use them. Generic flashing with premium skylights often creates more problems than it solves.

Curb-Mounted Skylights

Curb-mounted skylights sit on a raised frame built into the roof. The curb must be minimum 4 inches above the finished roofing surface. The skylight unit sits on the curb with a compressible seal. Flashing consists of: a step flashing system on the sides (same as chimney flashing), a saddle or cricket on the high side to divert water around the curb, and apron flashing on the low side that integrates with the roofing. The high-side cricket is the most frequently omitted component — and the most common source of leaks on curb-mounted units.

Deck-Mounted Skylights

Deck-mounted skylights include an integrated self-flashing frame that sits directly on the roof deck. Most premium manufacturers include a step-flashing kit that integrates with shingles. Follow the installation sequence exactly — shingle integration is specific to each unit. The temptation to "figure it out" rather than read the instructions leads to installation that looks right but leaks under high wind-driven rain.

Build Your Own House? 42-page guide • 27 construction steps • 40+ years of field-tested knowledge
Get the Guide — $29

Interior Finish Details

The light shaft (the framed tunnel from the skylight to the ceiling) must be insulated and air-sealed. An uninsulated light shaft is a major thermal bridge in winter. Condensation on the skylight frame indicates inadequate interior temperatures — either from insufficient insulation or air leakage at the light shaft penetration.

The Bottom Line

Use manufacturer-specific flashing kits. Build a cricket on the high side of curb-mounted units. Read and follow the installation instructions. Inspect the flashing integration with roofing before the crew moves off the roof. The 30 minutes of careful inspection prevents the inevitable callback.

Ready to Build Smarter?

Get the complete 42-page owner-builder guide — 27 construction steps from a builder with 40+ years experience and 1,000+ homes.

Get the Guide — $29
★★★★★
"This guide saved me from making a $40,000 mistake on my foundation. Worth every penny of the $29."
— Marcus T., Bozeman, MT

Free Building Tips — Straight to Your Inbox

Get practical construction advice from a builder with 40+ years and 1,000+ homes. No spam, ever.