Pressure-treated lumber is one of the most commonly misspecified materials in construction. There are multiple preservative types, multiple retention levels, and specific applications where each is appropriate. Using the wrong PT lumber in the wrong application is a code violation and a future callback.
How Pressure Treatment Works
Treatment forces preservative chemicals deep into the wood fiber under pressure. The chemicals bond with wood cells and resist fungi and insects. "Pressure treated" doesn't mean rot-proof — it means decay-resistant under conditions where the wood will get wet. Continuously submerged in water, buried in direct contact with soil, or improperly detailed, even PT lumber will eventually fail.
Modern Preservatives
CCA (chromated copper arsenate) was phased out for residential use in 2004 due to arsenic concerns. Modern residential PT lumber uses copper-based preservatives: ACQ (alkaline copper quaternary), CA (copper azole), and MCQ (micronized copper quaternary). These copper-based preservatives are significantly more corrosive to metal than CCA was — which is why hardware specifications changed. Use only hot-dipped galvanized or stainless steel fasteners with modern PT lumber.
Retention Levels
The retention level tells you how much preservative is in the wood, measured in pounds of preservative per cubic foot of wood (pcf). Above-ground use (decks, railings) requires 0.15 pcf. Ground contact requires 0.40 pcf. Below ground, in contact with concrete in extremely aggressive environments, requires 0.60 pcf. The end-tag stamp tells you the retention level and use classification. Specify and verify — suppliers sometimes mix inventory.
Where PT Is Required by Code
IRC Section R317 specifies where treated wood is required: sill plates on concrete, exterior decks, wood in contact with the ground, wood within 8 inches of grade, wood framing in bathrooms, and wood near pools and hot tubs. These aren't suggestions — inspectors check.
Handling and Cutting
When you cut PT lumber, you expose untreated wood at the cut end. Field-treat cut ends with an approved end-cut preservative before installation. Wear gloves and eye protection when cutting — the preservatives are still chemicals. Don't burn PT lumber offcuts — the smoke contains copper compounds.
The Bottom Line
Check the end tag. Match the retention level to the application. Use compatible hardware. Treat cut ends. These four steps prevent the callbacks that show up 5–10 years after the job.