More water damage starts at windows and doors than any other building component. Not because the windows leak — but because the flashing around them fails. Proper flashing is a specific sequence of overlapping layers that directs water outward. Get the sequence wrong and water runs behind the WRB into the wall.
The Shingle Principle
All flashing works on the shingle principle: upper layers overlap lower layers so water always runs down and out, never behind. Think of it like roof shingles — each layer sheds water onto the layer below. At a window, this means the sill flashing goes on first (bottom), then the side flashing overlaps the sill, then the head flashing overlaps the sides. Reverse any overlap and water gets in.
Sill Flashing (Bottom)
The sill is where water collects and sits. Apply a sill pan — either a formed metal pan, a flexible membrane like Vycor or FlexWrap, or a liquid-applied flashing. The pan must slope outward (toward the exterior) so water drains out. Turn up the edges at the sides (dam ends) to prevent water from running off the edges and behind the WRB. The sill pan goes directly on the rough opening framing, under the WRB at the bottom.
Side (Jamb) Flashing
Flexible flashing membrane runs vertically on both sides of the rough opening, overlapping the sill pan at the bottom. The flashing covers the gap between the window frame and the rough framing. It extends onto the face of the WRB (housewrap) at the exterior. The key detail: at the bottom, the side flashing overlaps the sill pan. At the top, the head flashing will overlap the side flashing.
Head Flashing (Top)
Head flashing goes last. It can be a flexible membrane or a metal drip cap. It overlaps the top of the side flashing and tucks under the WRB above (the WRB overlaps the head flashing on the exterior). This ensures any water running down the wall surface flows over the head flashing and onto the WRB below — never behind it and into the rough opening.
Common Mistakes
The most common error is cutting the WRB at the bottom of the window and tucking it under the sill flashing — this creates a reverse lap that channels water behind the WRB. The correct method: cut a modified I-cut in the WRB (horizontal cut at the sill, vertical cuts at the corners angled up), fold the flap under at the sill, and fold flaps out at the sides and top. The bottom WRB tucks behind the sill pan. The top WRB laps over the head flashing.
Tape vs. Membrane vs. Liquid
Flexible membrane (Vycor, FlexWrap) is the most reliable for sill pans — it's thick, self-sealing at fastener penetrations, and moldable into corners. Flashing tapes work for sides and head but are thinner and less forgiving. Liquid-applied flashings (like Prosoco or Zip Liquid Flash) are excellent for irregular substrates and create seamless, monolithic coverage. Each has its place — use what works best for each location.
Test Your Work
After installing windows with proper flashing, do a simple water test: spray water at the window from a garden hose, starting at the bottom and working up. Check for any leaks inside. This takes 5 minutes and catches flashing failures before drywall covers them. A small investment in testing prevents very expensive water damage repairs later.